Please Read Me First Before UsingYour Unbound® Cordless Auto Curler From Conair®

 

Banner/Header: Quick Start

 

Charge fully overnight before first use. Charge time may vary depending on type of adapter and power source being used. It’s best to use a 2.4 amp adapter for the quickest charge time.
 

Left image: Unbound Cordless AutoCurler digital display showing battery meter. Right image: The autocurler on/off button.
1. Battery icon  2. On/Off Button

Step 1:

Once battery icon stops flashing and 4 bars are displayed, turn on the unit by pushing the ON/OFF button for 2 seconds.

 

Step 2:

Use the MODE and SETTING buttons to select temperature, curl direction and timer settings.

 

 

Left image: Unbound Cordless AutoCurler digital display showing the heat icon. Right image: Hands inserting a half inch section of hair into the curl chamber.
3. Set the heat to desired Temperature  4. Place a 1/2" section of hair into the curl chamber.

Step 3:

Once the heat icon stops flashing and you hear a beep, the unit is ready to use.

 

Step 4:

Start with a 1/2" section of hair and insert it into curl chamber. For longer hair, take smaller sections.

 

 

Left image: Unbound Cordless AutoCurler digital display showing the start button. Right image: Hands pulling the auto curler away to release the hair curl.
5. Press and hold the start button  6. Release start button at 2 beeps and pull the curler down to release the curl

Step 5:

Press and continuously hold the START button to begin curling. The button should be held for the duration of the timer setting.
 

Step 6:

Release the START button when you hear 2 rapid beeps. Pull the auto curler down to reveal the perfect curl.

 

The styler will operate for up to 60 minutes.

 

Please Note: In-use time will vary depending on the heat and timer settings selected, as well as hair type.

 

Auto-off feature for added safety and preserves battery life.

 

Please Note: If the unit is switched on and idle for more than 15 minutes, it will automatically shut off. This does not mean the battery is dead. If you want to continue using the styler, press and hold the ON/OFF/MODE button for 2 seconds to turn it on again.

 

 

For more information, please refer to the instructional booklet